Make a Cardboard Bunny Tissue Box Holder

With Easter just around the corner, bunnies, chicks, and carrots seem to be  popping up everywhere.  Since I had some practice crapting a whale tissue box holder, I thought I'd try making a bunny tissue holder for Easter.

Meet Pinky.  

This little rabbit is my newest cardboard animal creation.  

She's super girly and cute.

And bonus- her tail provides comforting tissues when you sneeze.

Chuck can't resist pulling on her tail...

Want to crapt your own?  Read on!

Materials:
- cardboard (not bent, in good condition)
- pencil
- exacto knife
- self healing cutting mat
- scissors
- packing tape
- ruler
- paint
- paint brushes
- Sharpie markers
- Mod Podge

Directions:
Step 1:  Measure and cut out your pieces from cardboard.  (See pdf below) You'll need:
a.  1 long rectangular piece (15 3/4 inches x 5 1/2 inches)
     - folded lengthwise every 5 1/4 inches
     - with two tiny, thin rectangular holes cut out from middle section (for ears)
     - with two rectangles cut out from each side (for feet)

b.  2 identical ear pieces (about 4 1/2 inches tall)
     - bent 1/2 inch from bottom
     - two tabs cut at bottom (tape tabs down to attach ears)

c.  1 bottom piece (5 1/4 inch x 5 1/2 inch)
     - sides will probably be trimmed down and corners rounded when you assemble pieces

d.  1 front and 1 back piece (5 1/4 inch x 5 1/4 inch)
     - rectangle cut out from bottom of both pieces (for feet)
     - circle (approx 1 1/2 inch in diameter) cut out from back piece (for tissue tail)

Bunny Tissue Holder Measurements

Step 2:  Bend the long piece into three equal 5 1/4 inch parts.  (I found that it helped if I first scored the cardboard with my ruler or scissors).

Step 3:  Carefully tape front piece in front of your bent piece  (It was easier to maneuver smaller pieces of packing tape.  Try your hardest to make sure that the tape sits right against the cardboard.)

Step 4:  Attach bottom piece with tape.  Before taping, make sure that your tissue box fits into your construction.  You may need to trim the edges of the bottom piece and round off some corners to make sure that it fits.  (Honestly, I wish I trimmed a bit more off my bottom piece.  It's still slightly too wide and it pushed the sides out in a funny way.  So, I ended up taping them down from the outside... which ruined the effect a bit... )

Step 5:   Place your tissue box into the cardboard container.  Then, attach the back piece with packing tape.  (First I taped the top of the back piece to the bent long piece.  This created a nice hinge effect and the back piece could open and close.  I could have left it like that, but with Chuck on the loose it was safer if I taped the feet portions together too.)

Step 5:  Paint your piece.  (Honestly, I liked the au natural look.  But, pink just felt more spring-y, so I went with it.) To protect the tissue tail, push a plastic bag into your hole.  Pull it out when you're done.  Don't forget to use Mod Podge to protect your paint job.

And there you have it- some bunny to hand you tissues when you need them.  (Har, har, har.... )

Pin It